19
ISSUED: 2012-10-11 SHEET #: 180-9041-2 2012-05-31
Amplifi er Setup
Connect the desired audio sources to the unit. Turn on the ampli
fi
er using the Main Power
Button (
NOTE:
Remote control function will not work unless the unit Main Power has been
turned on). Ensure that the Power Indicator light is solid Green. Adjust volume to desired level.
Setup HDS200 transmitter and AV sources. (See HDS200 Quick Start Guide or User Manual for
instructions, WL-AU-AVWSA models only). Once complete, test audio from AV sources. Press
the vol+ and vol- arrows on the Ampli
fi
er remote control. If using a PC as the audio source,
ensure headphone output is enabled and volume is at least half.
For Wireless Microphone setup, continue to step 14. Otherwise, skip to step 15.
Wireless Microphone Setup
When a wireless microphone system is installed, the relative gain to the HDS200 needs to be
set.
For fi xed level sources (Blu-Ray® player):
1. Play source with ampli
fi
er volume at a comfortable level.
2. Adjust mic gain the the back of the ampli
fi
er while talking into the microphone to allow
vocals to be slightly louder than the
fi
xed source volume.
3. Con
fi
rm no feedback or "mic hotness" is present at high ampli
fi
er volumes.
4. Fine tune as necessary.
12
13
14
Attach cover assembly (
H
). Install seven M5 x 6mm screws (
I
). Remove protective
fi
lm from
cover assembly (
H
).
I
H
15
PROTECTIVE FILM
(REMOVE)
For variable level sources (PC):
1. Set variable source level at 25%.
2. Adjust mic gain on the back of the ampli
fi
er while talking into the microphone to allow
vocals to be slightly louder than the variable source volume.
3. If at max mic gain on ampli
fi
er, and the microphone is not loud enough, lower variable
source volume and repeat adjustment steps.
4. Con
fi
rm no feedback or "mic hotness" is present at high ampli
fi
er volumes.
5. Fine tune as necessary.
Summary of Contents for WL-AU-AVWS
Page 2: ......