3
ISSUED: 2012-10-11 SHEET #: 180-9041-2 2012-05-31
NOTE:
Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List................................................................................................................................................ 4
Installation to Double Stud Wall ............................................................................................................. 6
Installation to Metal Stud Wall ............................................................................................................... 8
Installation to Solid Concrete or Cinder Block......................................................................................10
Component Connections......................................................................................................................17
Ampli
fi
er................................................................................................................................................18
Ampli
fi
er Setup......................................................................................................................................19
Wireless Microphone Setup...................................................................................................................19
Tools Needed for Assembly
• stud
fi
nder ("edge to edge" stud
fi
nder is recommended)
•
phillips screwdriver
• drill
• 3/8" bit for solid concrete surface
• 3/16" bit for wood studs
• 1/2" bit for metal studs
• socket wrench
• 7/16" socket
• level
• hammer
• Pencil
• Tape Measure
• Do not begin to install your Peerless product until you have read and understood the instructions
and warnings contained in this Installation Sheet. If you have any questions regarding any of the
instructions or warnings, for US customers please call Peerless customer care at
1-800-865-2112, for all international customers, please contact your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience
with basic building construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and
all attached hardware and components.
• Never exceed the Maximum UL Load Capacity. See page one.
• If mounting to wood joists ceilings, make sure that mounting screws are anchored into the center
of the studs. Use of an "edge to edge" stud
fi
nder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws
fi
rmly, but do not overtighten. Overtightening can damage the items, greatly
reducing their holding power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product
failure and personal injury.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
HARDWARE REQUIRED
•
Wood
Stud
Included
•
Wood
Joist
Included
•
Solid
Concrete
Included
• Metal Stud
Included (Not Evaluated By UL)
•
Brick
Contact
Quali
fi
ed Professional (Not Evaluated By UL)
• Other or unsure?
Contact Quali
fi
ed Professional
WARNING
Summary of Contents for WL-AU-AVWS
Page 2: ......
