peerless-AV XACE-01, Manual

2

2019-09-26    #:180-9135-4    (2020-08-25)

Relevant Information

Record your products model and serial number here for future reference. Keep this user manual in an accessible 

location in the event service is required.

Model Number ____________________________________

Serial Number ____________________________________

Electrical Code

Note:

 To the system installer: Outlet shall be installed near the equipment and shall be easily accessible.  

Installation shall incorporate UL Listed external surge protection rated 2500 Vpk or less, for 150 to 300 Vac mains, 

installed in accordance with ANSI/NFPA 70 or applicable local codes.

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 

15 of the FCC Rule. These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with these instructions, may cause harmful interference to radio communications; however, 

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the equipment off and on, the user 

is encouraged to try to correct the interference by one or more of the following measures:

1.  Increase the separation between the equipment and receiver.
2. 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

3. 

Consult the dealer or an experienced Peerless-AV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

•  This device may not cause harmful interference.
•  This device must accept any interference received, including interference that may cause undesired operation.

Power Source

The product must be connected to a mains socket outlet with a protective grounding connection.

The mains plug is used as the disconnect device and shall remain readily accessible.

This product operates on 100-240 volts 50-60 Hz, AC current. Insert the power cord into a 120 volt 

60 Hz outlet. Never connect to direct current or anything other than the specified voltage.

To prevent electric shock, do not use with an extension cord, receptacle, or other outlet unless the blades and 

ground terminal can be fully inserted to prevent blade exposure.

All secondary lines must be routed through grounded conduit and kept separate from AC line.

Symbols

ENG

WARNING

ENG

Tools Needed for Assembly.

ENG

Do not overtighten screws.

ENG