6 of 32
ISSUED: 06-22-10 SHEET #: 061-9053-6 01-15-11
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen.
Place screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (
H,I
) on back of screen, align to holes, and center on back of screen as shown
below. Attach the adapter brackets to the back of the screen using the appropriate combination of screws and
washers and as shown in step 4-1.
NOTE: Top and bottom mounting holes on screen must be used for attaching brackets.
NOTE:
Be sure to attach tilt brackets with tilt adjustment screw facing outward as shown below.
Verify that all holes are properly aligned, and then tighten screws using allen wrench (
J
).
NOTE:
"X" dimensions should be equal.
CENTER BRACKETS
VERTICALLY ON BACK
OF SCREEN
X
X
TILT
ADJUSTMENT
SCREW
4
Installing Tilt Brackets
H
I
Begin with the shortest length screw, hand thread
through washer and tilt bracket into screen as
shown. Screw must make at least three full turns
into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three
full turns into the screen, select a longer length
screw from the baffl ed fastener pack. Repeat for
remaining mounting holes, level brackets and
tighten screws.
4-1
TILT BRACKET
(
H
,
I
)
SCREEN
WASHER
SCREW
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
