6 of 24
ISSUED: 08-09-10 SHEET #: 061-9058-4 10-18-10
NOTE:
Follow instructions with main enclosure assembly for removal of bay door and vertical brackets.
Thread six 1/4-20 x .75" socket cap screws (
G
) with washers (
M
) through tilt plate (
B
), main enclosure assembly
(sold separately), seal washer (provided with enclosure assembly), and nylock nut (
H
) as shown below. Tighten all
fasteners using a 3/16" allen wrench.
6
Installing Tilt Plate to Main Enclosure Assembly
• Tighten screws so tilt plate (
B
) is fi rmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
WARNING
G
M
B
H
SEAL WASHERS
MAIN ENCLOSURE
ASSEMBLY
MAIN ENCLOSURE ASSEMBLY MAY APPEAR SLIGHTLY
DIFFERENT THAN ILLUSTRATED - SHOWN WITHOUT
BAY DOOR AND VERTICAL BRACKETS
