ISSUED: 02-18-09 SHEET #: 090-9165-1
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
2 of 8
NoTe:
Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List
.................................................................................................................................................................................3
Installation to Mounting Surface
.............................................................................................................................................
4
Control Bolt Tension Adjustment
.............................................................................................................................................
6
Arm Height Adjustment
...........................................................................................................................................................
6
Installation to Screen
..............................................................................................................................................................
7
Cable Management
................................................................................................................................................................
8
For customer care call (800) 865-2112 or (708) 865-8870.
WARNING
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity. See page one.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• Be sure to use designated fasteners and tools to assemble product. If correct fasteners and tools are not used,
product may fail.
• When using clamp mounted product do not install arm until clamp is securely attached to mounting surface.
• When a monitor is not attached to arm assembly, arm may swing upward and cause harm to you or damage to
product.
