7 of 34
ISSUED: 09-07-07 SHEET #: 202-9223-2 05-07-09
refer to Screen Compatibility Chart to determine the proper fastener to use. visit
www.peerlessmounts.com/1
for a full screen compatibility chart for this mount.
Begin with the shortest length screw, hand thread through washer and adapter bracket into screen as shown
below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten.
If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
Note:
Spacers may not be used, depending upon the type of screen.
refer to Screen Compatibility Chart to determine the proper fastener to use. visit
www.peerlessmounts.com/1
for a full screen compatibility chart for this mount.
Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into screen
as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
For Flat Back Screen
For Bump-out or Recessed Back Screen
ADAPTer BrACKeT (
BB
)
SCreeN
fig 2.1
WASHER
SCreW
2-2
2-1
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
SCreeN
WASHER
SCreW
ADAPTer BrACKeT (
BB
)
fig 2.2
SPACer
