4 of 6
ISSUED: 07-23-03 SHEET #: 201-9073-4 07-14-05
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
E
C
H
I
Insert holding pin (
H
) into wall support arm axle (
C
). Insert axle (
C
) through wall bracket (
A
) and lower swing arm (
E
). Lock
axle (
C
) in place with holding pin (
H
).
IMPORTANT: Be sure swing arm is in correct position shown below with plastic
cap at top.
Next thread snap ring (
I
) into groove at bottom of axle (
C
) protruding from wall bracket (
A
) as shown.
SNAP RING INSTALLATION:
Pull snap ring apart. Wind it around the tube while feeding it into the groove. Finish by
snapping the end of the snap ring into groove.
NOTE:
Fit of axle (
C
) into wall bracket (
A
) and lower swing arm (
E
) will be tight.
Gently tap into place with a hammer if necessary.
I
H
E
groove
1
3
2
groove
I
C
A
Insert swivel weldment (
B
) through swing arm (
E
).
Align holes in swivel bracket (
D
) with holes in swivel weldment (
B
) and secure with four M6 x 10 mm socket pin screws (
M
)
as shown.
D
J
NOTE:
Fit of rotation box
(
B
) into tube will be tight.
Gently tap into place with
a hammer if necessary
B
D
E
M
B
D
CORRECT POSITION
