3. Wipe off the shaft and oil it before inserting in the
pump. Use care not to bend shaft when inserting
thru bearings.
4. To adjust impeller, lay pump in a horizontal
position and push impeller toward the pump coupling
until it hits the discharge casing. With the impeller in
this position, loosen pump coupling set screw (38).
Using a 0.005 inch feeler gauge, set clearance
between bottom of ball bearing (14) and pump
pedestal (8). When clearance has been adjusted,
tighten pump coupling set screw (38). Place pump in
a vertical position and rotate shaft by hand. If
impeller rubs recheck clearance setting as outlined
above.
5. The float is adjusted as described previously
under installation.
NOTICE: Materials of construction, specifications,
dimensions, design features, and application infor-
mation, where shown in this bulletin, are subject to
change and/or modification without notice by
Peerless Pump at their option.
11
2899982
