ISSUED: 04-01-08 SHEET #: 055-9254-3 05-29-08
10 of 12
Visit the Peerless Web Site at www.peerlessmounts.com
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.
Cable Management
To make an opening to route cables through
projector mount assembly, adjust projector mount
assembly to full upward tilt position and maximum
left or right roll position by turning knobs for
adjustments as shown in figure 5.1.
NOTE: Be certain tamper resistant screws are
not engaged before making adjustments (see
step 6-1).
Route cables through top of extension column as
shown in figure 5.2 and figure 5.3.
NOTE:
A method for assisting cables through
extension column may be required (example: string
tied to connector to help pull through extension
column).
Route cables through projector mount assembly as
shown in figure 5.4 and connect to projector.
KNOB FOR TILT
ADJUSTMENT
MAXIMUM
WIDTH
1-9/16"
(40 mm)
HEIGHT DIMENSION
WILL VARY DEPENDING
ON WIDTH DIMENSION
DO NOT
CRIMP
WIRES
BEND WIRES OF RCA
PLUGS IN OPPOSITE
DIRECTION
MAXIMUM DIMENSIONS
EXTENSION COLUMN
WILL ALLOW
fig. 5.4
fig. 5.1
KNOB FOR ROLL
ADJUSTMENT
OPENING FOR
ROUTING CABLES
ROUTE
CONNECTOR
THROUGH
FIRST
fig. 5.3
CABLES WITH COMBINATION
OF VGA CONNECTOR
AND RCA PLUGS
5
EXTENSION
COLUMN
fig. 5.2
