8 of 46
ISSUED: 10-30-09 SHEET #: 095-9297-2 12-04-09
Begin with the shortest length screw, hand thread screw through multi-washer and screen brackets (
B
) into screen
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
NOTE:
Spacers may not be used, depending upon the type of screen.
Begin with longer length screw, hand thread screw through multi-washer, screen brackets (
B
) and spacer in that
order into screen as shown below. Screw must make at least three full turns into the mounting hole and fi t snug
into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw
from the baffl ed fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
For Flat Back Screen
For Bump-out or Recessed Back Screen
2-1
2-2
SCREEN
MULTI-WASHER
SCREW
B
SCREEN
MULTI-WASHER
SCREW
SPACER
B
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
