8 of 27
ISSUED: 05-18-05 SHEET #: 095-9234-4 08-23-05
3
Adjust tension knob on side of mount shown in figure
3 to desired tension to balance your screen size and
weight.
Push or pull from top or bottom of screen to adjust
tilt as shown. The tilt can be adjusted to a maximum
of 15° forward or 5° backward.
• Be careful not to pinch fingers when opening and
closing mount from the wall.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount.
Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
TENSION KNOB
Note:
Make sure cords have enough slack to allow full movement of the arm.
Route cords inside arm slots of wall mount (
A
) as shown in figure 4.1.
Optional:
Run power cord through one side of
mount and signal cable(s) through other side in order to avoid interference with the signal.
Lock cords into place by sliding cord covers (
I
) onto mount as shown in figure 4.2. Screen may have to be moved for
better access for sliding on the cord covers.
fig. 4.1
A
4
fig. 4.2
I
fig. 3
