4 of 5
ISSUED: 07-26-05 SHEET #: 024-9009-2 12-01-06
C
Rotate toggler
clockwise to
wedge it
against inside
walls of metal
stud.
Push into
hole.
Pivot end of
toggler.
Slide plastic
cap forward
while pulling
back firmly on
ring.
Break off
excess.
Note:
Wall plate (
A
) can be mounted on 24", 20", or 16"
centers.
Using a stud finder, locate and mark the edges of the
metal stud used in mounting this product. Use of an
edge to edge stud finder is highly recommended.
Use a level to draw a vertical line down the center of
the stud. Use wall plate (
A
) as template to mark
center of slots along the vertical line. Drill four 1/2"
(13 mm) dia. holes through drywall and studs. Insert
togglers (
C
) as shown below.
1
C
∅
1/2"
(13 mm)
• Make sure that mounting screws are anchored into
the center of the studs. The use of an "edge to edge"
stud finder is highly recommended.
WARNING
