18
A N IMPORTA NT NOTE ABOUT WIND
For Large WEATHER PICTURES only: Wind speed
functions should be selected for display only in the Numeric
Displays located within the wind direction compass rose.
These Numeric Displays may also be used to display any
other desired data.
VII
.
INST A LLING A DDIT IONA L NUMERIC DISPLA Y S
Additional Numeric Displays are easily installed using only a small
Philips screwdriver.
1)
First, remove power from the WEATHER PICTURE by
unplugging it from its AC adapter. Then, place the WEATHER
PICTURE face down on a soft flat surface. Laying a soft towel
down first is recommended to help prevent scratching the
nameplate. Remove the back plate by removing the 8 screws
(the large WEATHER PICTURE has 11 screws).
2)
Note that the existing Numeric Displays are daisy-chained
together in a red+black+yellow wire harness. Open the Numeric
Display wire harness "loop" by unplugging the pair of white plastic
connectors in closest proximity to where you're installing the new
Numeric Display. Opening the wire harness "loop" allows you to
install a new module (which, when plugged in, will "close" the
loop.)
3)
Install the new Numeric Display using the four screws
provided. Be careful not to pinch any wires under the Numeric
Display or screws. Plug the new Numeric Display's 7-WIRE plug
into the 4-WIRE plug of the connector pair you unplugged in Step
2. Likewise, plug the new Numeric Display's 4-WIRE plug into
the 7-WIRE plug of the connector pair you unplugged in Step 2.
The Numeric Display wire harness "loop" is now closed again.
4)
Follow instructions of previous section for setting Display
Function DIP switches, and for installation of Display Labels.
5)
Carefully replace the back plate, making sure all
red+black+yellow wires and connectors are positioned so that
they are not pinched, and replace the screws.
