CONNECT SYSTEM COMPONENTS
Refer to Wiring Diagram A or B in the section "Installing Your
ULTIMETER
2000 Components." Connect components by
plugging cables into receptacles as shown.
TO DISPLAY WIND DIRECTION
After installation, the
ULTIMETER
2000
will constantly indicate the
prevailing wind direction on its 16 point compass rose. The
system minimizes confusing "jitters" by ignoring momentary
direction changes that occur during transient wind gusts. It also
avoids erroneous readings, by "locking" the wind direction display
when there is no wind, i.e. when the cups are not spinning.
Therefore, in order to test or demonstrate the wind direction
function, you must spin the cups. You'll find it is best to blow
somewhat steadily on the cups, rather than abruptly spinning the
anemometer rotor with your fingers.
TO DISPLAY WIND SPEED, WIND CHILL, TEMPERATURE,
BAROMETRIC PRESSURE, HUMIDITY, DEW POINT, TIME, OR
DATE
Press and release the desired data key:
,
,
,
,
H
,
d.p.
,
, or
.
The corresponding symbol
will appear on the screen and the current data value will be
displayed.
NOTE: When you press
or
H
, the instrument will
display the outdoor temperature or outdoor humidity.
TO DISPLAY INDOOR TEMPERATURE OR INDOOR HUMIDITY
a) Press and release
to display outdoor temperature or
H
to display outdoor humidity.
b) Next, press and release
to change display from
outdoor reading to indoor reading.
4
