Peg-Perego VIAGGIO 1 Via, Instructions For Use Manual

23

 IMPORTANT: take hold of the straps under the 

shoulder pads and pull, as shown in the figure.

17 

To loosen the safety belt, press the button at the 

centre of the car seat (1) under the fabric cover and 

simultaneously loosen the safety belt (2).

 IMPORTANT: take hold of the straps under the 

shoulder pads and pull, as shown in the figure.

18 

The car seat has a booster cushion which is only 

suitable for small babies (maximum 12 kg) and for 

when the harness is at the first level. To remove the 

booster cushion, release the buttons on its sides (1) and 

slide it out of the side straps (2). 

  How to adjust the seat and head rest

The headrest must be adjusted to match the child’s 

height. There are several positions.

 19 

To switch from a low to a higher position: pull the 

tongue at the centre of the head rest (1) upward; the 

head rest simultaneously lifts (2).

To switch from a high position to a lower one: pull the 

lever in the upper central part of the headrest upwards 

and, at the same time, push the headrest down to the 

desired position.

When you have finished, slightly move the headrest to 

check it is properly locked into place.

 20 

To determine the best shoulder strap position, bear in 

mind that the child’s shoulders must be just below the 

shoulder strap guides.

 21 

 IMPORTANT: the safety belts should not be too 

above or below the child’s shoulders.

 22 

The Viaggio 1-2-3 Via car seat can be reclined into several 

positions.

To recline the seat, pull the lever under the seat (1) and 

adjust the seat to the desired position (2).

  How to switch the car seat from Group 1 

to Group 2-3

 23 

Lift the head rest (1) and remove the shoulder pad 

hooks (2) located behind the backrest and under the 

belt, as illustrated.

24

  Release the Velcro and, from the front, remove the 

shoulder pads from the straps.

 25 

Store the shoulder pads for future use.

26

   Lift the headrest cover and slide the straps through the 

slots in the plastic structure.

27

   Remove the booster cushion; then unfasten the 

automatic buttons on the seat, lift up the fabric, and 

open the panel underneath.

28

   Pull the crotch strap out of the seat fabric, then fasten 

the straps and close the panel, ensuring the straps slide 

through its side slots.

29

   Raise the backrest by one position to make it easier for 

the vehicle’s seat belt to slide through. 

 30 

The safety belt must freely pass under the side of the 

child seat.

 31 

The child seat is correctly switched to Group 2-3.

  Child car seat, Group 2-3, "Semi-

universal" category with ISOFIX

  •  Type approved under standard 

*%

, for 

children of weight from 15 to 36 kg (3 to 12 years 

approx).

  •  This child car seat is classified as “semi-universal” and 

can be fitted on the seats of car models specified in the 

list attached to these instructions.

  •  The child car seat can only be used in approved cars, 

fitted with safety belts with three static fixing points or 

winder, homologated in accordance with standard ECE 

R16 or equivalent regulations. The car seat should be 

equipped with ISOFIX anchors.

IMPORTANT: the use of safety belts with two 

fixing points or an abdominal fixing point is 

forbidden.

  •  Viaggio 1-2-3 Via  must always be installed faced 

forward only on seats with ISOFIX connectors.

  •  Do not install Viaggio 1-2-3 Via in seats that are not in 

the direction of travel or are transversal with respect to 

the direction of travel.

  •  It is always advisable to fit the child seat on the rear 

seats and on the passenger’s side.

  •  If the child seat is installed on the front seat, it is 

advisable to place it as far as possible from the 

dashboard.