Peg-Perego VIAGGIO 1 Via, Instructions For Use Manual

24

  •  This item has a progressive serial number.

  •  If you experience problems during the installation of 

Viaggio 1 2 3 Via, lift or remove the headrest.

  How to install the Viaggio 1-2-3 Via car 

seat

 32 

Pull the yellow lever at the front of the seat base (1) 

and fully eject the ISOFIX anchors (2).

 33 

Secure the ISOFIX anchors in their housings until they 

click; a red/green LED on the sides of the base will 

indicate correct anchoring.

 34 

Pull the yellow lever (1) and simultaneously push the 

child seat (2) firmly against the car seat.

How to secure your child in the Viaggio 

1-2-3 Via car seat

 35 

Seat your child (fig_a) and pull the car 3-point harness 

as illustrated (fig_b).

 36 

Fasten the seat belt, ensuring that it clicks into place. 

Position the two sections of the belt as shown in the 

figure.

 37 

To finish, pass the belt from the shoulder straps on the 

head rest: insert the belt between the strap and head 

rest (1) until is easily slides in the strap slot (2).

 IMPORTANT: if the belt is loose, pull over the 

strap (3). Verify that the belt is always tensioned 

and untwisted.

 38 

To remove the belt, remove it from the strap slot (1) 

and slide it between the strap and head rest (2) until 

fully removed.

  How to adjust the seat and head rest  

 39 

 the safety belts are correctly positioned if the 

child’s shoulders are slightly below the intersection 

point of the safety belts, as shown in the figure. 

Adjust the head rest to the desired position using the rear 

lever.

 40 

Follow your child's growth to guarantee correct belt 

passage. To further increase height, lift the backrest to the 

desired position using the side buttons.

 41 

The side flaps can be widened for further adjustments as 

illustrated.

 42 

Viaggio 1-2-3 Via reclining can be adjusted. Make sure 

the belt is always correctly fastened. If the car has an 

adjustable seat back, it can be reclined for maximum 

Viaggio 1-2-3 Via reclining (fig_a). If the seat back cannot 

be adjusted, if the car head rest interferes with the child 

seat head rest, remove the car head rest (fig_b).

 43 

To remove the child seat from the car seat, move the child 

seat away from the car seat by pulling the lever (1) and 

seat (2) simultaneously until the yellow side levers appear. 

If used, release Top Tether.

 44 

Once the side levers are visible, release as illustrated and 

remove the child seat.

  How to remove the fabric cover

The fabric seat of the Viaggio 1-2-3 Via can be removed 

for cleaning.

 45 

Follow the washing instructions on the seat package.

REMOVE THE LINING FROM THE HEADREST.

 46 

Remove the lining from the head rest from the bottom 

and then top

REMOVING THE LINING FROM THE BACKREST

 47 

 Remove the bottom part of the backrest lining 

(fig_a) and lift the two side flaps vertically out of their 

housings (fig_b). Lift the head rest for easier removal.

REMOVING THE LINING FROM THE SEAT:

 48 

Unbutton the buttons on the side of the seat. Remove 

the lining towards the front of the seat

   Maintenance and cleaning of the fabric 

lining

Brush the fabric parts to remove dust.

  •  Follow the washing instructions on the label sewn onto 

the seat's lining. (fig. 49)

  •  Do not use chlorine bleach.