42
SLOW OR FAST GEAR SWITCH
FAST GEAR
The pallet truck achieve the max speed turning completely the forward switch (see page
12 “Tiller head” n° 02).
The forward and backward gear occurs only with the Tiller head in inclined position.
The tiller in the upright or downright position completely stop the pallet truck.
SLOW GEAR:
The max speed achieve with this function is reduced.
The tiller position is indifferent because the function of slow gear allow the movement of
the pallet truck also with the tiller head in the upright or downright position.
This function is particularly useful in limited spaces.
FAST GEAR: Pallet truck can operate with
the max speed and only with the tiller
inclined.
SLOW GEAR: Pallet truck can operate only
at reduced speed also with the tiller in the
upright position.
100%
V. MAX
M
F
F
30%
V. MAX
M
F - BRAKING
M - RUNNING
43
PUTTING IN FUNCTION AND PALLET TRUCK UTILIZATION
PRELIMINARY CONTROLS:
The
ready to use must be in the following conditions:
stacker
1) Battery charger plug: disconnected.
2) Slow and fast gear switch: fast gear selected.
3) S
.
tart key: activated
4) Tiller bar: in vertical position
LIFTING AND LOWERING OPERATIONS
1) Introduce the forks in the lower part of the pallet on which the load is put with
maximum of care and minimum speed; it is recommended for a bigger stability of
the load to introduce completely the forks (see page 10 “Transport of load”).
2) Control that the load is equally distributed on the forks and the positions of the
barycenter is within the limits shown by the arrow on the
.
stacker
3) For lifting: keep pushing the button for lifting (reference page 12 “Tiller head” no. 4)
until the desired height is achieved.
4) For lowering: keep pushing the button for descent (reference page 12 “Tiller head”
no. 4) until the desired height is achieved.
ATTENTION!
The load lifting and lowering operations should be
executed only with the pallet truck completely stopped.
BACKWARD
FORWARD
FORWARD AND REVERSE MOVEMENT OPERATIONS:
1) Check that slow and fast gear
has the slow
switch
gear selected.
2) Introduce the start key.
3) Push simultaneously with both hands the tiller head and
bring it in a quite horizontal position: in fast gear mode
the positions completely horizontal and vertical forbid
the forward and reverse movement .
4) Operate the butterfly control buttons for movement:
turning in the sense of watch needles the stacker moves
forward, in the contrary sense the pallet truck moves
reverse. Controlling in an adequate manner the turning
there it is easy to control the pallet truck speed.
It is advised to avoid abrupt and repeated starts and
slowing down in order to avoid overheating of the motor
and rapid discharge of the battery.
Summary of Contents for TPL 16-20-30
