5
3. Connecting to Your PC
DC-7010 can easily perform data management, unit configuration and battery charge via the bundled
cradle.
The battery supplied in each terminal unit has been partially charged at the factory. It is recommended to
charge the battery before first use.
You can install the terminal unit to the bundled cradle and charges the battery either from USB or RS-232
interface cable.
3.1. Connecting to Your PC and Charging the Battery
3.1.1. Connecting to PC by the cradle with USB interface cable:
Connect the USB interface cable to the USB port on the PC. The ORANGE power LED in front of
the cradle would be lighted. The cradle is ready for recharging the battery or terminal configuration.
Place the terminal onto the cradle. You may hear a beep sound when the terminal is placed onto
the cradle if the SETTING item “Key Click” is set to “Enable”.
There is a LED indicator on the top of the terminal and lit RED.
In the Display of the terminal there is a battery status icon indicates the battery status.
As the battery is being charged, the battery status icon is varying and indicates the battery is
charging. It takes approximately 6 hours to charge from low battery status..
When the battery is charged completely, the battery status icon will turn to static and indicated the
battery is full (dark icon). The terminal RED LED turns off.
＊
To install USB driver of DC-7010, please refer to “
4. Communication / Utility
” for further information.
USB Connector
