pela tools 506799, Manual

Security and troubleshooting

• 

If the machine for some reason runs badly, 

stop immediately by pressing the ”stop” button. 

The wheel stops right away.

• 

Press the ”start” button without the protective 

hood down, the machine does not start and the 

display shows Err-5.

• 

If the main shaft does not rotate, and the 

display shows Err-1, check the motor, 

motherboard and cable connections.

• 

If the main shaft rotates and the display shows 

Err-1, check sensors, motherboard and cable 

connections.

• 

If the machine does not stop after the 

balancing is finished check the braking 

resistance, the power supply, motherboard and 

cable connections.

• 

If the display only shows dashes when you turn 

on the power switch, a self-calibration may 

need to be performed, an adjustment of 

sensors or possible replacement of sensors.

• 

If the display shows something abnormal when 

the machine is switched off, turn off the power 

and count to 10 - switch on the power again - if 

is not normal after that please contact us.

Maintenance & care

• 

Make sure that the machine always is clean.

• 

Before maintenance, always start by pulling out 

the plug.

• 

Check the belt tension: pull out the plug and 

remove the hood. The strap must be able to be 

pushed approx. 4 mm downwards in the 

middle.

• 

Adjust by loosening the engine mounting 

screws and adjusting the engine position - 

check that the belt does not come loose 

laterally.

• 

Check that electrical parts are not damaged.

• 

Check that the screw on the balance shaft is 

not loose, use an Allen key if necessary to 

tighten it.

• 

If the display does not light up, check the power 

indicator light. If not, there is a problem with 

the power supply. If it flashes, please check the 

power supply in the balancer, computer and 

cable connections.

• 

Precision problems are not usually caused by 

the balancing machine. This is often due to 

incorrect wheel installation or incorrect balance 

weight, or incorrect weight on the 

self-calibration weight. Please save the original 

100 gram counterweight in a safe place as it is 

necessary for self-calibration.

• 

Instability and poor repeatability of data are not 

usually caused by the balancing machine. This 

is usually due to incorrect wheel installation, 

or that the machine is not properly anchored. 

Check the machine’s anchor bolts. If the 

machine is not connected to a grounded 

electrical outlet these problems can 

sometimes occur.