EN 14
General
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero. Contact the service
department.
This appliance is set for 1-phase operation!
If your home installation is not fitted with 32 Amp fuses, the appliance’s
total power consumption must be limited (power limiter) so that the
power consumption does not rise above 16 Amp. Not all zones can be
used at full power if the power limiter is activated. The appliance will
beep and the display will flash the set power when the maximum power
consumption has been reached.
Set the appliance to ‘Lo’:
• Within 2 minutes of connecting the appliance to the electric power
press all 4 cooking zone selection buttons simultaneously. Keep
these pressed down for at least 3 seconds.
• ‘Hi’ will appear in the display.
• Push the ‘-’ or ‘+’ button and select ‘Lo’ in the display.
• Again press all 4 cooking zone selection buttons and keep these
pressed for at least 3 seconds.
Fault list
When in doubt on the proper operation of your appliance, this does
not automatically mean there is a defect. Try to address the problem
yourself first by checking the points mentioned below or for more
information visit the 'www.pelgrimservice.nl' website.
Symptom
Possible cause
Solution
The fan runs on for several
minutes after the hob has been
switched off.
The hob is cooling down.
Normal operation.
A slight smell is noticeable the
first few times the hob is used.
The new appliance is heating
up.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
You can hear a ticking sound
in your hob.
Ticking can also occur at lower
settings.
Normal operation.
ERRORS
Summary of Contents for 493237
Page 1: ...Manual induction hob Anleitung Induktionskochfeld IDK465ONY ...
Page 18: ...EN 18 ...
Page 34: ...DE 18 ...
Page 35: ...DE 19 ...