EN 21
CLEANING
If the force applied to close the door is too strong, the effect of the
system is reduced or the system will be bypassed for safety.
1. First, fully open the door (as far as it will go).
2. Rotate the stoppers back by 90°.
3. Slowly close the door until the stoppers are aligned with the hinge
beds. At the angle of 15° (relative to the closed door position),
slightly lift the door and pull it out from both hinge beds on the
appliance.
To replace the door repeat these actions in reverse. If the door does not
open or close properly, make sure the hinges are positioned correctly in
their slots.
Always ensure that the catches fit properly in their slots. Never
allow the hinge fitting to spring out because the central springs are
very strong and can cause injury.
Removing the oven window
The glass in the oven door can be cleaned from the inside, but you do
need to remove the glass from the door to do this. First remove the
oven door (see chapter ‘Removing the oven door’).
Summary of Contents for OVM516MAT
Page 54: ...EN 28 ...