1
2
Remove Wiring Module from the TS200(H)
thermostat. Install Wiring Module inside of
the air ahndler.
Refer to page 4 of a TS200(H) Installation
Guide.
Some installations may have limited in-wall wiring. Use this configuration if no Data Wire or
Commmon Wire is available. A common application would be to monitor supply air temperature
with limited wires.
Login to your Pelican Site Manager Web Application. Select Admin > Thermostat Setup fpr
the thermostat which has the newly attached TA1. Scroll down until you see a category
labeled “Wired Sensor”
Select the correct Function for your TA1 sensor:
– “Temperature” to use the TA1 sensor instead of the thermostat’s internal temperature
sensor or to allow averaging between the TA1 sensor’s temperature sensor and the
thermostat’s temperature sensor.
– “Alarm” to use the TA1 sensor as an interface for a Dry Contact alarm input. Select whether
a notification should be sent when the contact is opened or closed.
– “Temp Monitor” use the TA1 sensor as a stand alone temperature monitoring device.
(ie. supply air temperature or outside air temperature monitoring).
For additional assistance visit www.PelicanWireless.com to request support.
Connect the R, C, and D terminals from the
Wiring Module to matching terminals on the
TS200(H).
Connect the R, C, D terminals from the
Wiring Module to the matching terminals on
the TA1 sensor.
Note:
The sensor can then be used for any one of
the three examples shown on page 3.
Alternate Limited Wiring Option
Wiring Module
TS200(H) Thermostat
TA1 Sensor
Configuration
3
Up to 500'
max distance
between devices.
4
Rc
R
C
D
Y W G W Y
2
2
D C R
D C R
T
D
C
R
Systems
Pelican
Wireless
Wiring Module
Model: WM500
Power: 24-30 VAC
PelicanWireless.com
