3
UPPER AND LOWER MOUNTS ASSEMBLY
ENSURE ADEQUATE CLEARANCE FOR
LID OPENING. CHECK THAT LATCHES
ON OPEN LID DO NOT CONTACT REAR
WINDOW OF TRUCK CAB.
4
4.1
4.2
FIT & SECURE
PLACE CASE IN DESIRED TRUCK BED
LOCATION TO DETERMINE LOCATION OF
MOUNTING BRACKETS.
IMPORTANT: CASE MUST BE CENTERED
LEFT TO RIGHT TO PROPERLY SECURE CASE
WITH CROSS-BED MOUNTING SYSTEM.
ASSEMBLE UPPER AND LOWER MOUNTS
TO BRACKETS
FIT TWO (M8 X 16) CARRIAGE BOLTS IN
SQUARE HOLES FROM TOP OF UPPER MOUNT
THROUGH SLOT IN LOWER MOUNT. FASTEN
(M8) LOCK NUTS LOOSELY TO ALLOW
SLIDING ADJUSTMENT LATER.
PLACE EARS OF UPPER MOUNT BETWEEN
BRACKET EARS, WITH (M10) NYLON FLAT
WASHERS BETWEEN METAL EAR SURFACES.
FIT (M10 X 25) BUTTON HEAD BOLTS.
FASTEN (M10) LOCK-NUTS SNUGLY BUT STILL
PERMITTING ROTATION OF MOUNT. THIS
ALLOWS SWINGING OF MOUNTS OUT OF
WAY WHEN INSTALLING/REMOVING CASE
FROM TRUCK.
REPEAT FOR SECOND MOUNT ASSEMBLY.
3.1
(M8 X 16)
CARRIAGE
BOLTS
CHECK THAT
LATCHES ON
OPEN LID DO
NOT CONTACT
REAR WINDOW
OF TRUCK CAB
(M8)
LOCK NUTS
(M10)
NYLON FLAT
WASHERS
(M10 X 25)
BUTTON
HEAD BOLTS
(M10 X 25)
LOCK NUTS
UPPER MOUNT
BRACKET
EARS
LOWER MOUNT
UPPER
MOUNT
EARS
SLIDE PAIR OF NUT PLATE
ASSEMBLIES INTO BED RAIL.
POSITION NUT PLATES TO LINE UP
WITH MOUNT ASSEMBLY AND FIT
FOUR (M8) LOCK-NUTS. PARTIALLY
TIGHTEN NUTS TO ALLOW SLIDING
ADJUSTMENT WITH CASE POSITION
AND OPPOSITE MOUNT ASSEMBLY.
REPEAT WITH INSTALLATION OF
MOUNT ON OPPOSITE SIDE OF CASE
AND TRUCK BED.
4
4.3
4.4
4.4
4.5
FIT & SECURE
SLIDE NYLON RETAINER WASHERS
FIRMLY AGAINST NUT PLATES TO
TIGHTLY SEAT SQUARE BOLT FEATURES
IN SLOTS AS SHOWN.
ASSEMBLE FOUR (M8 X 30) CARRIAGE
BOLTS THROUGH SLOTS IN NUT PLATES TO
NYLON RETAINER WASHERS.
NYLON RETAINER
WASHERS
(M8 X 30)
CARRIAGE
BOLTS
(M8)
LOCK NUTS
3
4
