INTeRIOR FINISHING
If products cannot be finished immediately, cover with clear plastic to protect from dirt, damage and
moisture. Remove any construction residue before finishing. Sand all wood surfaces lightly with 180
grit or finer sandpaper. DO NOT use steel wool. BE CAREFUL NOT TO SCRATCH THE GLASS.
Remove sanding dust.
Pella products must be finished per the below instructions; failure to follow these instructions voids the
Limited Warranty.
• On casement and awnings, it is optional to paint, stain or finish the vertical and horizontal sash edges.
• On single-hung and double-hung, do not paint, stain or finish the vertical sash edges, any finish on
the vertical sash edges may cause the sash to stick; it is optional to paint, stain or finish the horizontal
sash edges.
• On patio doors, it is optional to paint, stain or finish the vertical and horizontal panel edges.
Note: To maintain proper performance do not paint, finish or remove the weather-stripping,
mohair dust pads, gaskets or vinyl parts. Air and water leakage will result if these parts are
removed. After finishing, allow venting windows and doors to dry completely before closing them.
Pella Corporation is not responsible for interior paint and stain finish imperfections for any product
that is not factory-applied by Pella Corporation. Use of inappropriate finishes, solvents, brickwash, or
cleaning chemicals will cause adverse reactions with window and door materials and voids the
Limited Warranty.
For additional information on finishing see the Pella Owner's Manual or go to
www.pella.com.
IMPORTANT NOTICe
Because all construction must anticipate some water infiltration, it is important that the wall system
be designed and constructed to properly manage moisture. Pella Corporation is not responsible for
claims or damages caused by anticipated and unanticipated water infiltration; deficiencies in building
design, construction and maintenance; failure to install Pella
®
products in accordance with Pella
installation instructions; or the use of Pella products in wall systems which do not allow for proper
management of moisture within the wall systems. The determination of the suitability of flashing and
sealing systems are the responsibility of the Buyer or User, the architect, contractor, installer, or other
construction professional and are not the responsibility of Pella.
Pella products should not be used in barrier wall systems which do not allow for proper management
of moisture within the wall systems, such as barrier Exterior Insulation and Finish Systems, (EIFS)
(also known as synthetic stucco) or other non-water managed systems. Except in the states of
California, New Mexico, Arizona, Nevada, Utah, and Colorado,
Pella makes no warranty of any
kind on and assumes no responsibility for Pella windows and doors installed in barrier wall
systems. In the states listed above, the installation of Pella Products in barrier wall or similar
systems must be in accordance with Pella’s installation instructions.
Product modifications that are not approved by Pella Corporation will void the Limited Warranty.
eXTeRIOR FINISH
The exterior frame and sash are protected by aluminum cladding with our tough EnduraClad
®
or
EnduraClad Plus baked-on factory finish that needs no painting. Clean this surface with mild soap and
water. Stubborn stains and deposits may be removed with mineral spirits. DO NOT use abrasives. DO
NOT scrape or use tools that might damage the surface.
Use of inappropriate finishes, solvents, brickwash or cleaning chemicals will cause adverse reactions
with window and door materials and voids the Limited Warranty.
CARe AND MAINTeNANCe
Care and maintenance information is available in the Pella Owner’s Manual. You can obtain an owner’s
manual by contacting your local Pella retailer. This information is also available on
www.pella.com.
