PELLA
®
DESIGNER SERIES
®
BETWEEN-THE-GLASS BLINDS AND SHADES WITH INSYNCTIVE
®
TECHNOLOGY
|
12
REPLACING BATTERIES
See
InsynctiveSupport.Pella.com
for how-to videos.
The battery pack used in this product is recharged by the solar cell
or by using the Pella
®
Insynctive
®
WALL CHARGER. Battery life is
dependent upon a number of factors such as number of charge/
discharge cycles and average temperature in the environment.
Battery life is expected to exceed three
years in most applications.
When the battery reaches the end of its life, it will lose its charge
quickly and will require charging with the wall charger on a more
frequent basis. Contact your local Pella sales branch to purchase a
replacement battery.
WARNING:
Batteries carry the risk of fire, explosion and burns.
Do not disassemble or incinerate. Failure to change battery
properly when low will impair BLIND or SHADE performance.
IMPORTANT NOTES:
— BLIND or SHADE does not need to be resynced to REMOTE or
BRIDGE following a battery change.
— Properly dispose of used batteries based on your local
requirements. A best practice is to dispose of batteries at your
local home chemical collection center.
California Only:
Contains
perchlorate material. See www.dtsc.ca.gov/hazardouswaste/
perchlorate for any special handling regulations.
ADDING AN ADDITIONAL REMOTE OR DELETING A REMOTE
These procedures may be used to sync or delete a REMOTE from
BLIND or SHADE. A total of 8 REMOTES may be synced to BLIND
or SHADE.
•
Touch the top end of REMOTE to BLIND or SHADE cover
approximately 6" from the end where the wire connects.
Move REMOTE back and forth slowly until BLIND or SHADE
completes a quick up/down motion to indicate that BLIND or
SHADE has entered sync mode.
— To add a new REMOTE, press and hold the Up button on
the new REMOTE until BLIND or SHADE completes a quick
up/down motion to acknowledge that new REMOTE was
successfully synced.
— To delete a REMOTE, press and hold the Down button
on REMOTE until BLIND or SHADE completes a quick
up/down motion to acknowledge that REMOTE was
successfully deleted.
ADDITIONAL INSTRUCTIONS
(continued)
SOLAR
PANEL
COVER
REMOTE
MEASURE 6"
FROM END WHERE
WIRE CONNECTS
BATTERY
