PELLA
®
DESIGNER SERIES
®
BETWEEN-THE-GLASS BLINDS AND SHADES WITH INSYNCTIVE
®
TECHNOLOGY
|
13
“HOMING” THE BLIND OR SHADE
Over time, you may notice that the fully opened position for raise-
and-lower BLINDS or bottom-up SHADES or the fully closed position
for top-down SHADES has drifted. This is due to normal wear and
use of BLIND or SHADE and can be corrected by homing BLIND or
SHADE. The homing process will cause BLIND or SHADE to move up
until it is fully compressed. BLIND or SHADE then resets the position.
To initiate the homing process, press and hold the Up button on
REMOTE until BLIND or SHADE reaches the top point of travel,
then release the button. Press and hold the Up button for about 5
seconds until BLIND or SHADE begins to move up. BLIND or SHADE
will stop moving when fully compressed and will reset the fully
opened or closed position.
RESETTING TO FACTORY DEFAULTS
This procedure will reset all BLIND or SHADE positions to factory
default settings.
• Slide the Hinged Glass Panel (HGP) latch releases side to side
or up and down to open the HGP.
• Locate the small hole in the top cover about 4" from the end
where the wire connects.
• Insert a paper clip or other small tool into the hole, and
depress the reset switch for about 3 seconds.
• BLIND or SHADE will move to top position to acknowledge
successful reset.
ADDITIONAL INSTRUCTIONS
(continued)
UP
BUTTON
DOWN
BUTTON
LED
LIGHT
CENTER
BUTTON
WIRE
BLIND OR
SHADE
COVER
HGP
LATCH
RELEASE
FACTORY
RESET
SWITCH
