Pella Rolscreen Installation, Operation And Care Instruction Download

Page: 2 / 5

Installing the Screen (continued):

NOTE:

Do Not remove cardboard shipping spacers

from guides until after the guides are
installed.

NOTE:

The Rolscreen guides are handed; make

sure the profile of the bottom of each
guide properly aligns with the sill stop
profile.

Place the top of a Rolscreen guide against

the frame with pull bar weatherstrip in

the guide channel.

(It may be necessary to

reposition the pull bar to facilitate proper
installation of the guide.)

Position the bottom of the guide against the
frame and on top of the sill.

NOTE:

It is critical the exterior side of each guide channel be positioned in the Rolscreen

assembly end cap as shown and the bottom of each guide touch the sill stop and is
pressed firmly against the jamb stops.

While pressing the guide to the frame; install the guide screws beginning with the

bottom screw (be sure to use a driver with #1 square head bit).

The number of screws will

vary depending on the height of the window.

Install the second guide,

repeating steps 1C – 1D.

Summary of Contents for Rolscreen





