BRUSH CUTTER EXCELION 2 DH
53_153238-A
1. Completely dismount the CITY CUT cutting head
(refer to the "dismount" part of Section 6.7.2,
« Changing the CITY CUT blades »).
2. Clean the areas indicated in the illustration opposite
using a flat screwdriver, compressed air, a brush or
hot water (only on the blades).
3. Dry all the parts using a clean, dry cloth.
4. Lubricate the blades using the PELLENC lubricant
spray (ref. 121633).
5. Refit the CITY CUT (refer to the "assembly" part of
Section 6.7.2, « Changing the CITY CUT blades »).
6.7.4. SHARPENING THE BLADES
1. Visually check the blades.
If any of the blades are twisted or bent, they should
be discarded.
To equip yourself with new blades, see Section 9,
« Accessories and consumables ».
2. Proceed with the sharpening of the blade, taking
care to maintain an inclination of 45° between the
blade and the file.
70
Summary of Contents for EXCELION 2 DH
Page 2: ......
Page 86: ......
Page 87: ......
Page 88: ...PELLENC Quartier Notre Dame 84120 Pertuis France...
