BRUSH CUTTER EXCELION 2 LH
53_154421-A
-
5.6.1.3. CITY CUT HEAD
This cutting head can be used in green spaces as well
as in the vicinity of homes. It was designed to limit pro-
jections and can therefore be used safely in urban areas.
For more information on the accessories available with your Brush cutter Excelion 2 LH, refer to Section 9.2, “Cutting
5.6.2. ADVICE FOR OPTIMIZING THE BATTERY
In order to optimize the autonomy of your PELLENC battery as much as possible, the rotational speed of the cutting
tool used must be adapted to the type of mowing.strimming work to be carried out.
This is because the higher the rotational speed of the cutting tool, the greater the energy consumption. Therefore
the progressive nature of the control trigger must be used to adjust the rotational speed of the cutting tool.
Type of vegetation or work
Recommended cutting tool
Recommended tool speed
Edges
TAP CUT 3 + PELLENC ELEC-
TRIC Ø 2.4 mm strimmer wire
S1
Lawn
TAP CUT 3 + PELLENC ELEC-
TRIC Ø 2.4 mm strimmer wire
V1
Grass
TAP CUT 3 + PELLENC ELEC-
TRIC Ø 2.7 mm strimmer wire
V2
Dense and tall grass
TAP CUT 3 + PELLENC ELEC-
TRIC Ø 2.7 mm strimmer wire
V3, V4
Tall, dense scrub brush
Twin-blade / Tri-blade
V3, V4
Brambles, plant re-growths, shrubs
Mulching blade
V3, V4
Thinning
Chisel-tooth saw
V2
Green spaces or surroundings of
homes (limitation of projections)
CITY CUT
V1 + City Cut mode on the HMI
5.6.3. TIPS FOR USE AND WORKING TECHNIQUES
1. Before starting mowing/strimming, examine the surface to be cleared: nature of the surface, area, relief, pres-
ence of obstacles, etc.
2. Note the wind direction. The latter may facilitate the removal of clippings and make the task of the user easier.
Important
Always keep a minimum distance of 50 mm between the cutting head and the obstacle in order to avoid any
risk of damage to the tool and the "strands" (of strimmer wire).
56
Summary of Contents for EXCELION 2 LH
Page 2: ......
Page 82: ......
Page 83: ......
Page 84: ...PELLENC Quartier Notre Dame 84120 Pertuis France...
