BRUSH CUTTER EXCELION 2 LH
53_154421-A
2. SÉCURITÉ
• The Brush cutter Excelion 2 LH is a professional tool whose use is reserved exclusively for clearing green spaces
(grasses, dense grasses, woody weeds, brambles and small shrubs).
• The PELLENC company accepts no responsibility for any damage caused by improper or unspecified use different
from its original intention.
• The PELLENC company accepts no responsibility for any damage caused by the use of non-original parts or
accessories.
• The company PELLENC also declines all responsibility in the event of damage caused by the use of mulching
blades with a diameter greater than 320 mm.
2.1. GENERAL POWER TOOL SAFETY WARNINGS
Warning
Read all safety warnings, instructions, illustrations and specifications provided with this
power tool.
Failure to comply with the following instructions risks causing electric shock, fire and/
or serious injury.
Retain all the safety measures and instructions for later reference.
Disconnect the battery before carrying out maintenance.
Note
The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated
(cordless) power tool.
2.1.1. WORK AREA SAFETY
1.
Keep the work area clean and well lit.
Cluttered or dark areas invite accidents.
2.
Do not operate power tools in an explosive atmosphere, for example in the presence of flammable
liquids, gases or dust.
Power tools create sparks, which can ignite dust or fumes.
3.
Keep children and bystanders away while operating the power tool.
Distractions can cause you to lose
control of the tool.
2.1.2. ELECTRICAL SAFETY
1.
The power tool connector must be adapted to the socket. Never modify the connector in any way what-
soever. Do not use adapter plugs with earthed (grounded) power tools.
Unmodified plugs and suitable
sockets reduce the risk of electric shock.
2.
Avoid contact with earthed surfaces such as pipes, radiators, cookers, and refrigerators.
There is an
increased risk of electric shock if your body is in direct contact with the ground.
3.
Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
4.
Do not misuse the power cord. Never use the cord for carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges and moving parts.
Damaged or entangled cords increase the
risk of electric shock.
5.
Use an extension cord suitable for outdoor use when operating power tools outdoors.
Use a cord suitable
for outdoors to reduce the risk of electric shock.
6.
Use a power supply protected by a residual current device (RCD) when the power tool is operated in a
damp location.
Use of an RCD reduces the risk of electric shock.
7
Summary of Contents for EXCELION 2 LH
Page 2: ......
Page 82: ......
Page 83: ......
Page 84: ...PELLENC Quartier Notre Dame 84120 Pertuis France...
