18
RECHARGING THE BATTERY
The module is delivered with the battery partially charged:
it is therefore necessary to put it through at least one
complete charge cycle.
When supplied with a solar panel (optional): during the
normal operating cycle, the solar panel helps keep the
battery module charged. In certain cases, e.g. solar
panel positioned on the north side of the building or in a
shady area, intense use, or very low temperatures, it may
nonetheless be necessary to recharge the battery also by
means of the charger SL2405, if provided.
If the battery needs recharging, the arrows will flash
red following an up or down command. Recharging is
automatically controlled by the battery module.
To recharge the battery:
1. Detach the battery module from the base plate;
2. Plug the battery charger into a power socket;
3. Plug the micro-USB connector into the port provided on
the module.
Summary of Contents for ScreenLine SL2776
