22
1. Detach the battery module from its base plate;
2. Press the programming button on the battery module
for at least 10 seconds. This will restart the device, as
confirmed by a steady yellow LED on the up arrow;
3. Release the button;
4.
Within 5 seconds from the release, press the
programming button once; the steady LED on the up
arrow starts to flash quickly (if the button is not pressed
again, the LED will turn off and the device will operate
normally);
5. Within 10 seconds hook the battery module onto the
base plate;
6. The base plate memory is written and the LED starts to
flash slowly;
7.
After 10 seconds, the module starts to operate
according to the newly programmed mode.
MOVING FROM STANDARD OPERATING MODE TO TILT-
ONLY MODE WITH BLIND SUPPLIED COMPLETELY RAISED
AND VICE-VERSA
1. Detach the battery module from its base plate;
2. Press the programming button on the battery module
for at least 10 seconds. This will restart the device, as
confirmed by a steady yellow LED on the up arrow;
3. Release the button;
4.
Within 5 seconds from the release, press the
programming button once; the steady LED on the up
arrow starts to flash quickly (if the button is not pressed
again, the LED will turn off and the device will operate
normally);
5. Press the programming button once again; the LED on
the up arrow turns off, and the LED on the down arrow
turns on flashing;
6. Within 10 seconds hook the battery module onto the
base plate;
7. The base plate memory is written and the LED starts to
flash slowly;
8.
After 10 seconds, the module starts to operate
according to the newly programmed mode.
Summary of Contents for ScreenLine SL2776
