PV50b pellet burner
p
19/ 24
Operation and maintenance
Replacing components
DK9801A2
www.pelltech.eu
In order to remove burner upper
cover, first open burner lower cover.
Then remove upper cover's screws
(10). Pull the cover upwards direction
shown in the picture.
NOTE:
it may be necessary to remove
user interface buttons from the
controller board to completely
remove upper cover from the burner.
Igniter
1) Disconnect burner from the power
network.
2) Open burner body.
3) Disconnect igniter wiring from the
control board X1, connector 1 and 2.
4) Loosen igniter fixation screw (11)
using cross-head screwdriver.
5) Remove igniter from the burner
body.
6) Install and connect new igniter vice
versa from removing.
10
10
11
