6
7
|
NOTICES
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
must not cause harmful interference,
and (2) this device must not accept any
interference received, including interference
that may cause undesired operation.
NOTE:
This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
1
Reorient or relocate the receiving
antenna.
2
Increase the separation between the
equipment and receiver.
3
Connect the equipment to an outlet on a
circuit different from that towhich the
receiver is connected.
4
Consult the dealer or an experienced
radio/TV technician for help.
CAUTION:
1
To comply with FCC RF exposure
compliance requirements, a separation
distance of at least 20 cm must be
maintained between the antenna of
this device and all persons.
2
This transmitter must not be co-located
or operating in conjunction with
any other antenna or transmitter.
Waste electrical products must
be handed over to a designated
collection point for disposal to be
recycled in an environmentally sound
manner. Improper disposal of this
product could result in harm to the
environment or to human health.
Check with your local waste authority
or the retailer where you purchased
this product for available collection
facilities or further recycling advice
Please avoid the generation of waste
from electrical products as much as
possible, e.g. by giving preference to
products with a longer service life or
by reusing used electrical products
instead of disposing of them.
You are responsible for deleting any
personal data from this product
before disposing of it.
This product is ANT+™ certified and
is compatible with ANT+ sensors
that support heart rate monitoring.
.
NOTICES
DISTRIBUTED BY:
US/CANADA
Peloton Interactive, Inc.
441 9th Ave, 6th Floor
New York, NY 10001
USA
UK
Peloton Interactive UK Limited
110 Long Acre
Covent Garden
London WC2E 9LH
United Kingdom
EU
Peloton Interactive Deutschland GmbH
c/o WeWork
Neue Schönhauser Str. 3-5
Neue Schönhauser Straße 3-5
10178 Berlin
Germany
AUSTRALIA
Peloton Interactive Australia Pty Ltd
ACN 644 958 047
20 Martin Place
Sydney NSW 2000
Australia
