4
Technical Specifications
For information about our other scale products, visit www.dymo.com.
Troubleshooting
Warranty
Your DYMO® Scale comes with a warranty against defects in materials, design, or workmanship, for one year from the
original date of purchase, when used in accordance with all operating instructions. Normal wear and tear is not covered,
nor is excessive use, abuse or damage caused by a user either intentionally or accidentally.
EXCEPT AS PROVIDED HEREIN, DYMO MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED, AND DYMO SPECIFICALLY
EXCLUDES WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DYMO’S LIABILITY UNDER
THIS WARRANTY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE SCALE. DYMO SHALL NOT BE RESPONSIBLE FOR
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, WHETHER OR NOT FORESEEABLE.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE
TO STATE AND COUNTRY TO COUNTRY.
In the event of a product failure, please visit www.dymo.com/support or contact DYMO Technical Support to obtain a
Return Material Authorization (RMA) number and further instructions to return your product.
Capacity
10 pounds (5000 g)
Resolution
0.2 oz. (5 g)
Units
ounces (grams)
Auto Shut Off
After thirty seconds of inactivity
Operating Temperature
40° - 104° F (4.5° - 40° C)
Power
9-volt alkaline battery or Pelouze
Adapter Model #ADPT2
Problem/Error Message
Solution
No display
Ensure the scale is plugged in, or replace the battery.
LOWBATTERY
is displayed
Replace the 9-volt battery.
Negative number is displayed
A tare value is displayed as a negative number when the items
are removed from the scale. Press
ZERO/HOLD
to reset the
scale to zero.
is displayed
The item on the scale platform exceeds the maximum capacity
of the scale. Remove the item immediately to prevent damage
to the scale.
Display reads
0.0
with an item on the
platform
This can happen because:
•
The Zero/Hold button was pressed while an item was on
the scale.
•
Power to the scale was disconnected or turned off and then
on again with an item on the scale.
In both of these cases, remove the item from the platform and
press the
ZERO/HOLD
button to return the display to
0.0
.
