Pelpro HHPP2, Owner'S Manual

 9 

P

P

LANNING

LANNING

& I

& I

NSTALLATION

NSTALLATION

C

C

HECK

HECK

L

L

IST

IST

Unless you are knowledgeable and experienced in stove installation, we recommend your PelPro Appliance   
receive a Pre-delivery Check and be installed by your local Specialty Retailer, NFI (National Fireplace Institute)  
Pellet Specialist (USA)  or WETT Certified Installer (CAN) . 

COMPLETE THIS CHECK LIST PRIOR TO INSTALLING YOUR MULTI-FUEL APPLIANCE: 

_____     Carefully read this "Owners Manual”

. 

SAVE THIS MANUAL.

_____     Have your local Dealer 

demonstrate all the operational, cleaning and maintenance steps    

necessary for your stove. 

_____     Select a location.  

The design of your home and the stove placement will determine its value 

as a source of heat.  A pellet appliance depends primarily on air circulation to disperse its 
heat. There are other practical considerations, which must be considered before a final           
placement is decided on: 

Existing Chimneys, Pellet Fuel Storage, Aesthetic Considerations, Roof Design (rafter 
locations & roof pitch), Room Traffic, Clearances to Combustibles, and Existing Wiring.

_____     

The installation of this appliance 

must conform to local codes and applicable state and 

federal requirements. 

Becoming familiar with these requirements 

before

 installation is es-

sential.  

_____     

Sign and keep a copy of the

 Pre-delivery Check List supplied by your Authorized Dealer,  OR 

“Dansons Certified Installer”, found inside our appliance or available online.   

______  Attach your proof of purchase to this manual and keep on hand for warranty. 

COMPLETE THIS CHECK LIST WHILE INSTALLING YOUR MULT—FUEL APPLIANCE: 

_____     Carefully read the 

ENTIRE

 installation section first.   Twice is better. 

_____     Read the Installing Freestanding, Insert or Built-In  sections.  

_____     

Determine

 the location and measurement needed your chosen location. 

_____     

Be sure to pre-fit

 all items before you install, fasten or install the stove permanently.  

Remember measure twice, cut once. 

_____     

Ensure ALL

 joints of “PL” vent and single wall stainless steel liner are tightly connected,  

sealed with RTV Silicone or Hi-Temp foil tape

, 

including to the exhaust connector

, and 

is correctly installed.  (Follow vent manufacturer’s instructions.) 

COMPLETE THIS CHECK LIST PRIOR TO LIGHTING YOUR FIRST FIRE: 

_____    Obtain final inspection 

and approval by local building officials. 

_____    Carefully 

clean all marks off the brass, nickel or pewter parts

 before the first fire is lit.  Use a 

soft cloth and a gentle type cleaner.  

Caution

: Never use an abrasive cleaner on any part of your 

stove. 

_____    Polish the hopper

 to remove the oil type coating used in manufacturing. 

_____    

The high temp. stove paint used on your stove may take several hours of burning at a high fuel set-

ting to fully cure.  During this time an odor, which is not harmful, may be evident. The area around 
the stove should be well ventilated.

_____    

Review and follow the

 Lighting and Controls Instructions. 

 
_____    Ensure that appliance is connected to a surge protection unit. 
 
_____    Fill the hopper with quality pellets,

Close the Hopper Lid

,  Using the CCI “AcuTron”, 

               (figure 5), PUSH the 

FEED RATE

 Touch Pad and this will start the auger and the combustion fan. 

PelPro Home & Shop Heater                   www.pelprostoves.com                                9