P/N 82-00021 UM3105KL-AM_3105KG-AM_REV20220519
19
OPERATING INSTRUCTIONS (CONT)
Weighing a Patient and Taring a Known Weight / Pre-Tare
Pre-Tare can be performed within the following weight limits: 0.2 lb - 200 lb / 0.1 kg
– 91 kg)
1. Wait u
ntil “0.0” appears on the display.
2. Press and hold for approximately 3 seconds. The
display will change and prompt entry of the weight value to be
tared. Use the arrow keys to enter the weight to be tared.
Press to save the tare value.
3. The scale will zero and the tare value will show as a negative
weight
on the display. The word “TARE” will also appear at the
bottom center of the display along with the tare value.
4. Place the patient on the scale. The scale will automatically
deduct the tare value from the weight of the patient. The
display will show the pa
tient’s weight.
Note:
When in Tare
mode the screen will not show a prompt to enter height mode.
5. The weight may be held on the display by pressing .
The scale will con
tinue to display the patient’s weight after
they step off the scale and will remain on the display until
released or the scale is powered off. To release, press .
6. To reweigh the patient without removing them from the scale,
press .
7.
To see the patient’s weight in another unit of measurement,
press and hold down . . If the scale is in LB mode, it will
display the weight to KG. If the scale is in KG mode, it will
display the weight to LB.
Note:
This function is not available
on KG models or on KL models with Everlock
®
engaged or
with the
“Unit View” setting disabled.
8. To remove the Tare, press . The word
“TARE” will
disappear from the bottom of the display, and the tare value
will be cleared from the display. The scale will resume normal
operation.
Tare
Enter
Tare
Hold/
Release
Hold/
Release
Reweigh
Unit
