10
SET-UP INSTRUCTIONS
Powering the Scale
Plug the AC adapter into the power adapter jack (the jack is located on the rear of the display
head), then p
lug the scale’s AC adapter into the power source.
Warning:
To avoid a safety hazard, do not use an unspecified AC adapter. Only use the
Health o meter
®
Professional AC adapter model ADPT30 designed for this scale.
For battery operation, see Battery Installation below.
Battery Installation
1. If connected, unplug the AC adapter from
the power source. Use a Phillips head
screwdriver to remove the battery cover
on the side of the display head by
unscrewing the battery cover screw.
2. Remove the battery pack from the
display head. Replace or install fresh
batteries, making sure to install them in
the proper direction. Health o meter
®
Professional recommends using an
alkaline battery rated for 130°F (54°C)
operation. Do not use Zinc-Carbon
batteries.
3. Re-insert the battery pack into the
display head, ensuring the end with the
silver contacts is inserted facing the
inside of the display. Re-attach the
battery cover to the display head by
replacing the battery cover screw.
Warning:
If the scale will not be used for some time, remove the batteries to avoid a safety
hazard. Disposal of batteries must be performed in accordance with the prevailing national,
regional or local regulations that apply to you.
Power Adapter
Jack
