Set-up
15
4. Install the main unit
6
on top of the base unit. Firmly push the main unit
downwards until it locks into place (see
fig. C
).
A loud click sound can be heard on each side when the main unit has been
securely installed.
Please note that you may need to exert more effort to install the
main unit.
5. Install the CD waste bin
11
in the paper / credit card waste bin
12
(see
fig. D
).
6. Slide the paper / credit card waste bin into the base unit (see
fig. E
).
You must fully slide the paper / credit card waste bin into the base unit until
a click sound is heard. This indicates that the safety switch
7
has been
deactivated for normal operation.
The paper shredder is now assembled. Please note that the base unit
should not be disassembled.
Set-up
1. Make sure that the paper shredder is switched off (slide switch
8
at the
OFF position) before plugging it into an outlet.
2. Connect the power cord
1
to an outlet.
3. Set the slide switch to the AUTO position.
The paper shredder is now ready for use.
Shredding
WARNING!
Risk of injury!
Handling the paper shredder improperly may result in injury.
− Hold the paper by both sides when inserting into the feed
slot. Make sure that your fingers do not get too close to the
feed slot.
− Only hold the CD by the outer edge when inserting into
the feed slot. Make sure that your finger is not in the CD
hole, this can cause injury when the CD is drawn in.
− Hold the credit card by its narrow side when inserting into
the feed slot. Make sure that your fingers do not get too
close to the feed slot.
Summary of Contents for 95339
Page 3: ...3 A 1 2 3 5 6 7 4 8 9 10 11 12 13 ...
Page 4: ...4 B C 6 10 9 13 D E 12 11 12 ...
Page 5: ...5 G I F H 12 ...