Install Drivers for 9000 Boards
8
Chapter 3. Install Drivers for 9000 Boards
This chapter describes how to install drivers and other software that will allow your PenMount
9000 Control Boards (RS-232) work with various operating systems.
3.1.
Install PenMount DOS Driver
Before installing the DOS driver software, you must have the DOS system installed and
running on your computer. You must also have installed either PenMount 9026BH or
9036CH control board.
3.1.1.
Install PenMount DOS Driver
PenMount DOS Driver
version 2.10 diskette contains the following files:
INSTALL.EXE
-- PenMount installation program
PM2.EXE
-- PenMount Utility, to configure or test the PenMount
touch screen
PMOUSE.EXE
-- Driver loader, to load or unload driver.
PMTSR.COM
-- PenMount DOS Driver
PMOUSE.CFG
-- The configuration file for PenMount DOS driver
README.TXT
-- The file you're reading now.
PMINIT.BAT
-- Reload DOS driver batch file
PMUNLOAD.BAT
-- Unload DOS driver batch file
PMTEST.EXE
-- PenMount driver test utility to verify PenMount
driver working.
MOUSETST.COM
-- Mouse Test utility
If you have an older version of the PenMount DOS driver installed in your
system, please remove it first. PenMount 9000 control board has a 9-pin
D-sub connector. Before installation, plug into the COM port of PC. (e.g.
COM1, COM2, COM3 or COM4)
Follow the steps below to install the PenMount DOS driver.
Step 1
: Decompress the driver package. (e.g. C:\TEMP)
Step 2
: Go to the working directory. (E.g. cd \TEMP)
Step 3
: Run the installation program 'install.exe" at DOS prompt.
Step 4
: The install.exe will lead you to complete the installation.
Step 5
: Restart computer (Recommanded)
or
press 'ESC' key and issue 'SET
PENMOUNT=<penmount_installation_path>' at DOS prompt.
Step 6
: The PenMount driver will be loaded after restarting computer.
