Install Drivers for 9000 Boards
9
NOTE:
Environment Variable - PENMOUNT
The environment is variable, PENMOUNT needs PenMount driver
v2.10.
The installation program will put the command line 'SET
PENMOUNT=<penmount_install_path>' into the AUTOEXEC.BAT,
like:
SET PENMOUNT=C:\PM2 (e.g. PenMount installation path is
C:\PM2)
The driver can't be loaded, if the environment variable is not
configured properly and the utility can't be run. Issue the command
'set' at DOS prompt to check the environment variable.
Environment Variable - PATH
The installation program will put the installation path into the
environment PATH. You can run program in any working directory at
DOS prompt regardless of where the working directory is.
3.1.2.
PenMount DOS Driver Functions
The PenMount DOS driver offers several functions. You can change the
settings with the following utilities:
1. PM2 Panel
Run the batch file 'PM2.EXE'. Type the command at DOS prompt:
PM2
Before running PM2, you must remove PenMount driver or another
mouse driver, if you have installed one.
There are several functions to select, and the launch key is in brackets.
(E.g. press '2' key to do calibration)
Use <arrow key> (up/down) to select, and
<Enter>
to launch the
following functions:
(1) Draw
(2) Calibrate
(3) Detect
(4) Configure
(5) Packet
(6) Help
(7) Exit
2. Draw
Run the '
Draw
' in PM2 Panel, and use the arrow keys or hot keys (A~Y)
