Install Drivers for 9000 Boards
37
Example:
COM1= PCI, 38400
# Permanently install PCI RS232 38400bps at COM1
COM3= 6000,19200
#Permanently install PM6000 RS-232 19200bps at COM3
COM4=9000,9600
#Permanently install PM9000 RS-232 9600bps at COM4
PS. Set the symbol”;” in front of the parameter, which means not to perform the parameter.
Example:
;
TouchReport =2
，
it will not be installed as Digitizer mode directly in Windows Vista/ 7/ 2008/
WES7/ 8, the user can select Digitizer or mouse mode during the installation procedure.
;
COM1=PCI,38400
，
it will not install the driver at COM1 permanently.
3.6.1. Install PenMount Mouse Driver in Windows 2000/XP/XPT/
XPE/2003/VISTA/7/WES7/2008/8
If you have an older PenMount driver installed on your system, uninstall it first
and follow the steps below to install
PenMount Windows Universal Driver
:
Plug in your PenMount 6000 control board and install
PenMount Windows
Universal Driver
. Make sure the driver is installed before plugging the control
board. Then the driver will make the assigned COM port or USB port to detect
PenMount device.
To install the driver:
1. In
folder
PenMount Universal Driver
, find “
Setup.exe
” and run it.
2. A
License Agreement
window appears. Click “
I Agree
” and then “
Next
”.
3. When ready to install the program, click “Install”.
4. Installation takes some time.
5. When the warning message screen appears, please click “
Continue
Anyway
” to continue.
6. When the window below shows up, please select “yes” for installing
PenMount as mouse mode; select “no” for digitizer mode. If your
operating system doesn’t support Windows tablet input, digitizer device
can’t be used, therefore you have to select “yes” here, otherwise after the
installation the touch doesn’t work after re-booting.
