Driver Software Functions
52
The buttons on
“Tools”tab
have the following functions:
Draw
Tests or demonstrates the
PenMount
touch screen
operation.
Right Button Icon
Enable right button function. The icon can be shown on
Desktop
or in the
notification area
.
Gesture Enable
Enable/configure
Gesture AP
to support PenMount
gestures recognition.
Screen Rotation Monitor
The function supports
nVidia
,
Intel
,
SMI
or
ATI
and
software such as
Portrait Pivot Pro
rotation automatic
detection.
4.1. Standard
Calibration
Standard Calibration
allows touch screen match the display so that the point you where
you touch can be traced accurately on the screen.
Standard Calibration
only requires
four points for calibration and one point for confirmation. Under normal circumstance,
Standard Calibration
is all you need to perform an accurate calibration.
4.2. Advanced
Calibration
Advanced Calibration:
improve the accuracy of calibration by using the more
complicated engineering calculations. Use this function only if you have tried the
Standard Calibration
and there is still a discrepancy in the way the touch screen maps
to the display. You can choose 9, 16 or 25 points to calibrate, though we suggest that you
first try 9 points, if it is still not tracking well then try 16 or 25 points. The more points you
use for calibration, the greater the accuracy. Errors in calibration may occur due to
viewing angle, or individual skill, and there may be little difference in using 16 or 25 points.
A stylus is recommended for the most accurate results.
4.3. Multiple
Monitors
PenMount mouse drivers for Windows
2000/XP/XPE/2003/VISTA/72008/WES7/8
support
Multiple Monitors
.
Multiple Monitors
supports from two to six touch screen
displays for one system. Each monitor requires its own PenMount touch screen control
board, either installed inside the display or in a central unit. PenMount control boards
must be connected to the computer COM ports via the RS-232 interface. Driver
installation procedures are the same as for a single monitor. Multiple Monitors supports
the following modes:
Windows Extend Monitor Function
Matrox DualHead Multi-Screen Function
nVidia nView Function
NOTE:
Multiple Monitors
function is for use with multiple displays only. Do not use
this function if you have only one touch screen display. Please note once you
turn on this function
Rotating
function is disabled.
