19 INCH RACK MOUNT POWER DISTRIBUTION UNIT
OPERATION & USER GUIDE
Please read the following information before installing or
using your Power Distribution Units
Safety and Grounding (earth)
•
This PDU is intended for indoor use only.
•
Do not install this PDU where excessive moisture or heat is present.
•
Never install any wiring, equipment, or PDU's during a lightning storm.
•
Always connect this PDU into a three-wire, grounded power outlet.
•
The power input cable should be connected to appropriate branch circuit/mains protection
(fuse or circuit breaker). Connection to any other type of power outlet may result in a shock hazard.
•
Use only the supplied brackets for mounting.
•
Never work alone under hazardous conditions.
•
Check that the power cord, plug, and socket are in good condition.
•
Disconnect the PDU from the power outlet before you install or connect equipment to reduce the
risk of electric shock if you cannot verify grounding. Reconnect the PDU to the power outlet only
after you have made all connections.
•
Use a protective earth connector with equipment. This type of connector carries the leakage
current from the load devices (computer equipment). Do not exceed a total leakage current of
3.5mA or a risk of electrical shock will result.
•
Use the Stud Earth point on the back of the PDU to directly ground to the rack.
•
ALWAYS make sure the equipment that has been connected to the PDU is
OFF
, before switching on
the PDU, as the
Inrush Current
can blow the power fuse and activate the protection circuit.
•
All equipment plugged into this unit should have the correct fuses fitted for their current draw.
•
Penn Elcom Ltd excepts no responsibility or liability for any equipment connected to this unit
GUARANTEE
YOUR EQUIPMENT IS GUARANTEED FOR A PERIOD OF ONE YEAR FROM THE DATE OF PURCHASE OF THE PRODUCT AGAINST ANY DEFECTS DUE TO FAULTY
MATERIALS OR FAULTY MANUFACTURING. DURING THIS PERIOD, REPLACEMENT OR REPAIR TO THE UNIT WILL BE MADE WITHOUT CHARGE BY ANY
AUTHORISED DEALER OR THE FACTORY SUBJECT TO THE FOLLOWING CONDITIONS.
The fault must be entirely due to faulty materials or faulty manufacture.
The defect must
NOT
have been caused by poor installation, accidental damage, misuse or failure to comply with the instructions given in the users guide.
If at any time during the guarantee period a part or parts of the equipment are repaired with a part or parts
not supplied or approved by us; or if the equipment has been dismantled or repaired by any person not authorised by the us, then the guarantee shall
immediately cease and become void.
Evidence of the date of purchase must be produced at the service point to obtain the benefit of this guarantee. Any carriage charges relating to the guarantee
will be the responsibility of the purchaser.
This guarantee applies to the original purchaser only and the equipment must have been purchased or financed from new, this guarantee cannot be assigned or
transferred.
The company reserves the right to replace the equipment or repair it at their discretion, any defective part shall become the property of the company.
This guarantee applies to equipment purchased and used within the E.E.C. The importers of equipment in non E.E.C. countries are responsible for the guarantee
of this unit. Parts required under guarantee are free. Shipping charges for components will be charged at cost.
The guarantee shall become void if the equipment is at anytime used on any supply circuit or voltage range other than that specified on the equipment.
12. THIS GUARANTEE DOES NOT IN ANY WAY AFFECT YOUR STATUTORY RIGHTS AS A CONSUMER.
9-10 Parsons Road, Parsons Industrial Estate, Washington Tyne & Wear, NE37 1HB, UK
0191 416 1717 or www.penn-elcom.com
