Cascade Comfort System
10
System Cleaning (After Every Bath)
Clean and disinfect the spa after every bath with Penner Cleaner/Disinfectant as follows:
Note.
Penner Cleaner/Disinfectant is a special non-abrasive cleaning and disinfecting solution
that will not harm the spa’s fiberglass surface. Penner Cleaner/Disinfectant is the only
cleaning solution designed and recommended for use with your Penner Spa.
C
C
A
A
U
U
T
T
I
I
O
O
N
N
Some cleaners, disinfectants, and floor strippers contain ingredients that are corrosive
or abrasive. These solutions or compounds may contain chlorine, acid, basic ingredients
or abrasives. DO NOT allow such solutions or compounds to come in contact with your
Penner equipment. Failure to heed this caution could result in damage to the equipment
and void the warranty.
1.
Close and lock the door.
2.
Press the Tub Fill Button and turn the Temperature Control Knob all the way to the left to its
warmest level to heat the disinfectant solution and maximize its effectiveness.
3.
Remove any visible tissue, residue, or fluids from the spa by pressing the Shower Button and
rinsing the inside spa surfaces with the shower sprayer.
4.
Press the Tub Fill Button again to turn off the water. Allow the spa to drain, and place the
drain plug over the drain.
5.
Press and hold the Disinfect Button located on the control panel. As the button is held down,
the properly mixed cleaning solution is running through the air injection system and out all of
the air jets. Release the button after you see solution coming out of all the air jets and you
have 1 to 1 1/2 gallons of disinfectant solution in the foot well of the spa.
WARNING
Housekeeping personnel should wear protective glasses and gloves to prevent
disinfectant from damaging their eyes or skin. If disinfectant gets on the skin or in the
eyes, rinse thoroughly with plenty of water. Seek medical advice if irritation occurs.
6.
Using the long-handled brush, available from your Penner distributor; thoroughly scrub all
interior surfaces of the spa. Let disinfectant stay on surface for 10 minutes. (Or, as
recommended by the instructions on the disinfectant concentrate container.)
7.
Remove the plug from the drain.
8.
Rinse the spa’s interior surfaces thoroughly with the shower sprayer. (Continue with step16)
9.
Press and hold the Rinse button located on the control panel until clear water runs from all the
air jets. Then release the Rinse button.
10.
Finish rinsing the interior surfaces of the spa with the shower sprayer.
11.
Start the air blower by pushing the Aqua-Aire Button. Allow it to run for 30 seconds. This
pushes the rinse water out of the air injection system. If this was the last bath of the day, allow
the blower to run for 2 minutes to dry out the system.