BELL AND TULIP
FOUNTAIN
Adjust Bell or Tulip
by moving head
higher for small
bell and lower
for a wider bell
shape.
FOUNTAIN FLOW
CONTROL VALVE
Adjust fountain jet flow by turning
flow control valve.
FOUNTAIN BALL JOINT
Adjust the collar of the ball joint to
enable the extensions to be moved
compensating for a uneven pond floor.
Adjust height by unlocking collar then
pushing or pulling the telescopic riser
pipe (see "Getting to know your pond
pump" for parts descriptions). Optional
additional extensions can be added to
increase the height.
OUTLET FLOW CONTROL VALVE
Supply water features, waterfalls and filters
by adding 1" or ½" fittings and hose.
Adjust flow by turning flow control valve.
600/900 series
ADJUSTING DUAL CONTROL T PIECE
AND TELESCOPIC RISER PIPE
WATER FEATURE / FILTER / WATERFALL
Install as for Fountain. Depending on water feature to be supplied, your pond pump can
be used with the dual control T-piece 1" or ½" hose fitting (see "Adjusting dual control
T-piece" diagram). Hose clips should be used to secure hose.
Tip:
The larger 1” hose fitting will give maximum pump flow performance.
•
Ensure pipe work is not blocked, leaking or is laid so that it gets crushed or kinked.
•
Keep the height that water is to be pumped from the water surface (called Head) to a
minimum. The higher the head the lower the flow rate and the more wear on the pump.
•
Use the largest diameter, smoothest bore pond hose over the shortest distance and
keep hose fittings to a minimum. This removes frictional loss of flow and so increases
pump flow rates.
Also see the explanatory diagram on the top face of your pump carton.
INSTALLATION
1
4
3
2
1
4
3
2
9
