PENTAGRAM PathFinder Logger (P 3106)
EN - 5
LED Indicator
GPS status LED
– Orange (on) – acquiring satellites, GPS position not fixed.
– Orange (blinking) – GPS position fixed, navigation.
– Blue (fast blinking) – LED blinks 3 times, Point of Interest is recorded.
– Blue (slow blinking) – low memory (about 20%).
– Blue (on) – memory full, logging stopped.
Battery status LED
– Red (blinking) – Low battery.
– Green (on) – Battery charging.
– Off – Battery charging completed.
Bluetooth status LED
– Blue (on) – Bluetooth enabled, but connection not established.
– Blue (slow blinking) – Sleep mode.
– Blue (fast blinking) – Bluetooth connection established.
Getting Started
1.
Install and charge the battery.
2.
Turn on the GPS Bluetooth receiver.
Switch the mode switch to NAV or LOG position. The GPS status
LED turns orange and Bluetooth status LED turns blue (only in
NAV mode).
3.
Activate Bluetooth function of your PDA/PC.
Prior to activating the Bluetooth function of your PDA/PC, please
make sure the device is equipped with Bluetooth function, and the
driver software has been installed.
4.
Activate Bluetooth Manager & Established New Connections.
Illustrations using PocketPC:
a.
First, find the device with which you wish to establish
connection.
b.
Open „Bluetooth Manager” on your PocketPC.
c.
Follow the steps below.
