P/N 472091
2
Rev. B 4-16-02
P/N 472104
P/N 472105
P/N 472106
P/N 472107
WIRE #1
WIRE #2
WIRE #3
WIRE #4
WIRE #5
P/N 471129
P/N 471763
WIRE #6
ORANGE
ORANGE
BLUE
WHITE
RED
WIRE #P11
P/N 471812
MALE TERMINAL
MALE TERMINAL
FEMALE TERMINAL
FEMALE TERMINAL
18.0"
24.0"
18.0"
FEMALE TERMINAL
18.0"
FEMALE TERMINAL
ORANGE
ORANGE
MALE TERMINAL
MALE TERMINAL
FEMALE TERMINAL
18.0"
WHITE
18.0"
WHITE
WHITE
WHITE
FEMALE TERMINAL
ORANGE
24.0"
FEMALE TERMINAL
FEMALE TERMINAL
14"
18"
FEMALE TERMINAL
18"
30.0"
24.0"
FEMALE TERMINAL
18"
WHITE
FEMALE TERMINAL
FEMALE TERMINAL
WHITE
TERMINAL HOUSING
18"
MALE TERMINAL
FEMALE TERMINAL
B. WIRES IDENTIFICATION
The following items are new wire assembly, (provided in the kit).
A. INSTALLATION
1. Turn off the electrical power to the heater.
2. Open the heater’s right door.
3. Disconnect all wires from the 7800 Temperature Controller and the Ignition Module.
4. Remove the left and right doors from the heater if necessary.
5. Remove six screws on the rear cover of the 7800 Temperature Controller.
(
NOTE:
Please discard the cover, not used.
) Then, remove the cover, the PC board, and the front face carrier.
6. Install the 6800 Temperature Controller, (provided in the kit), by using four screws only. See Figure 1.
7. Remove two screws on existing Ignition Module and replace with new Ignition Module using the same two screws,
(provided in the kit).
Figure 1.
