Rev. F 5-02-01
3
P/N 99293200
• Turn off the power.
• Allow the old bulb to cool before you open the lid.
• Insert a flat screwdriver approximately 1" into the opening at the back of
the lid as shown:
WARNING
Turn off power before changing bulb. Failure to turn off power
may lead to severe electrical shock, which can result in death
or severe .
• Gently push the handle of the screwdriver towards the front of the unit,
while rotating the lid counterclockwise about an eighth of a turn as
shown in Figure 1.
• Lift the lid off and set aside.
WARNING
Bulb and socket are extremely hot during and following operation. Allow
sufficient time for cooling before touching them, or you may
suffer severe burns.
• Make sure the lamp and socket are sufficiently cool, then pull up on the
lever on the side of the lamp holder to eject the lamp. Place your thumb
on top of the socket to steady it while you lift the lever as shown in
Figure 2.
CAUTION
Do not touch the bulb or inside of the reflector with your bare fingers—
fingerprints can actually cause the bulb to overheat and crack. Handle the
bulb reflector by the outside surfaces only.
• Remove and discard the old bulb, and replace with spare, P/N 32504200
[white light model] or 23500100 [all other models]. Push the bulb into the
socket, holding the back of the lamp holder with your fingers as shown
in Figure 3.
• There is a spot to hold a spare bulb at the back of the Photon Generator
as shown in Figure 4. You can keep a spare bulb there so that it will
always be handy—no more hunting all over the house to find a spare
during the big party!
• Replace the lid by simply placing it with the screwdriver slot at the 11:00
o’clock position (looking down on the lid while standing in front of the
Photon Generator), and rotating until it clicks into place. Pull up gently
on the lid to make sure it is properly secured.
SECTION III. Replacing the Bulb
Bulb replacement in the FIBERworks Photon Generator is the easiest available! There are no screws to remove and lose, or
plugs to pull, and a spare bulb can always be kept handy, right inside the unit.
To change the bulb:
Figure 1
Figure 2
Figure 3
Figure 4
